TomatoUSB

I have been using my tomato with verizon with no issues. Currently it is using PPPOE. In couple of weeks I will be moving to comcast. I was googleing to see what i needed to change, I have seen bunch of posts from 2012 about problems with IPv6 and tomato. I am using Tomato Firmware 1.28.0000 MIPSR2-114 K26 USB Mega-VPN.

Assuming comcast is running on IPv6, my questions are:

• Does this build work with IPv6
• What do I need to do to move from verizon to comcast. I was under the impression that I needed to turn off PPPOE and hook the cable modem to the wan part and that would be it.
• Do I need to run my internal network in IPv6?
• I am currently using dynddns to reach my internal network. How would that work with IPv6

Thanks for the help

Turuncu

In case anyone is in my shoes here is what I did to get up and running

1. change PPPOE to DHCP
2. Set service type to DHCPv6 with prefix delegation.
3. Prefix Length 64.
4. Accept RA from WAN.
5. Put the following in Administration > Scripts > WAN Up

echo 0 > /proc/sys/net/ipv6/conf/`nvram get wan_iface`/accept_ra
ip -6 route flush default dev `nvram get wan_iface`
echo 2 > /proc/sys/net/ipv6/conf/`nvram get wan_iface`/accept_ra

After Script is in WAN Up reboot router.

nice, I'll need to bookmark this.