TomatoUSB

I updated from tomato 1.28 to shibby's mod tomato-ND-1.28.5x-112-VPN on a WRT54GL v1.1 and noticed the free ram went from about 50% to 4.43% (Total 14.04 MB / Free 636.00 KB (4.43%))

The router settings pages seem to load slower. I am just curious about this possibly causing a bandwidth problem? Does any one have any ideas? Also is it possible the previous configuration in tomato 1.28 caused some problem during the flash. I have nothing saving to ram. Everything goes to a CIFS Client. The free ram bounces around between about 5.56% and 4.43%. I am not sure if this will cause any problems. This router will be used as a bandwidth monitor and I needed vpn…

If anyone knows what the default ram usage would be from a fresh install of tomato-ND-1.28.5x-112-VPN (no previous configuration) that would be helpful. Or if there are any known issues with this build.

Thanks.

Hi,
On my wrt54gl v1.1 with the same firmware,
Uptime 13 days at this moment
Total / Free Memory 14.04 MB / 6,276.00 KB (43.67%)
Total / Free NVRAM 32.00 KB / 356 (1.09%)

2 or 3 computers wired + 1 wifi sometimes
Web Monitoring disabled
Internal logging disabled
Some wireless @mac filters
Some static DHCP IP
A lot of ports forwarding in memory, and some activated
Some Access Restriction rules
2 VPN servers activated

Are you sure you have clear NVRAM after flashing button enabled ?

I don't know if there's something with that… may be…

I recently changed the ashtray in my Porsche. Since then it seems to be slower and the brakes don't work.

Do you think Porsche will cover it under the warranty?

Thanks Petrusko,

Did you flash your router from a previous version of tomato to the shibby mod tomato-ND-1.28.5x-112-VPN, or did you flash it directly from the original linksys firmware.

I did not use the clear NVram after flashing to tomato-ND-1.28.5x-112-VPN. I currently have Total/Free NVRAM 32.00 KB / 12.80 KB (40.00%).

Tomato Shibby 108 > 112

Humm, I know it's annoying, but have you tried the 30-30-30 seconds hard reboot/reset ?
I think you can do this reset with Tomato Shibby 112, then go back in the web GUI to config one more time :s
Good luck !

Problem solved… I reset the NVRAM completely (in tomato there is an option) and then re-setup the router. My ram situation is currently:

Total / Free Memory 14.04 MB / 6,184.00 KB (43.03%)
Total / Free NVRAM 32.00 KB / 15.28 KB (47.75%).

Must have been something with not clearing the NVRAM after flash.

Thanks for the help!

That is good to hear. Now would you please help me get the brakes on my poorsh with the stuck ashtray working ? Thanks !