Today I downloaded tomatousb 2.4 NoUSB Std and uploaded to my Cisco Valet M10 v1. I received a message that installation was successful but after rebooting it I'm not able to browse to the router. I'm not sure what to do next and wonder if anyone has any suggestions.
Date: 19 Aug 2013 04:11
Number of posts: 7
RSS: New posts
Fuck me. I didn't read the compatibility list. M10 is not supported and I just fucked up my router with tomato firmware.
Warning to potential users of this forum: I wrote the first post did not write the second one.
I found pages that suggest Tomato does run on the Valet.
Does anyone have any helpful suggestions?
Hold your horses, I run TomatoUSB on two M10 v1's, but I flashed E1000 v1 CFE's to them first.
Kyle, I didn't flash the E1000 first. I'm guessing it's kaput but wonder if there's any way to talk to it via some Tomato mechanism? I"ve tried browsing to 192.168.1.1, .11, etc but haven't had any response. Is there another addr/port I could try? Or is there some magical reset I can do - hold down the reset button, the wifi button, and my nose etc?