TomatoUSB

Hey, I'm running shibby tomato on two routers, n66 (108) and n16 (110). The funny thing is that n16 doesn't pass through the ports I forward, no matter what I try. I mean I connect to n66 with 108 and port is open, and from the same computer I connect to n16 with 110 and port turns out to be closed (port forwarding is set up and IP address is set to static on both routers). What gives? I've been struggling with this for so long. The funny thing is that the n16 is a fresh install, I did 30x30x30 reset, and then nvram erase from GUI after upgrading to shibby 110. I'm at my wit's end with this thing, wonder if I should go back to 108 or 109 or something, I'm pretty sure I didn't have these problems with shibby 108 on n16 as I don't right now with 108 on n66u

a bit more detail: n66u has MIPSR2-108 K26 USB AIO-64K and n16 has MIPSR2-110 K26 USB AIO

One more thing - the wan ports are connected to the same ISP, so ISP is not the issue.

Just upgraded and found that port forwarding seems to work fine. I think it is your misconfiguration and will be hard to comment anymore without knowing what exactly you configured that's not working.

I installed Shibby v110 clean on an ASUS RT-N66U (it has to be installed via firmware recovery mode) and I had immediate and unresolvable problems with port forwarding. UPNP / NAT-PMP didn't work either.

I downgraded to v109 and that resolved the issue.

I have tested and "port forwarding and UpnP" working as they should in 110-aio!
Have you erased NVRAM before and after your upgrade if not test and reconfigure, don't use old config file.

Have you erased NVRAM….

Awe HELL no. That is like telling somebody to reboot their Windows 98 machine when the printer quits working. They lie to you when they call and say they just rebooted. You tell them to reboot again so you can read the BIOS info and suddenly the printer is working just fine.

Erasing nvram are for gays and losers. Don't do it!

Erasing nvram are for gays and losers. Don't do it!

Dude, are you GHEY? Or are yor just F'uking around ? All that shit you just post3d is it is really none of my business, but an NVRAM clear and re-porgram from scratch is some purdy good shit. If you are Ghey and are looking for some fresh cock to suck, then this forum is not going to produce anything worth a shit for you. I'm jus sayin', and could be wrong. Above all else, GeeTek sucks no dick and buys good putang as financed financed permit. This information has been privied simply in interst of providing positive and producive info to those of you still reading and flow the thread. LET IT BE KNOWN THAT GEETEK HAS NO INTEREST IN SHIT RIMMED SMELLY ASSholes or PORTS AS COMPARED TO FeMALE FRUIT.

Nobody around here in my my opertain is involved in voyers sucking themselved into penile succion / stimaulation, so if that is what you are into then just say so. With the proper info we can all get along and Tomato progress may continue accordingly. Fags suck dick and tomato firmare imporves home grade router operataiton. Simple as that. All un-related.

I help the end users as my knowledge permits, and sickduckers are at the end of the list, less the occasional reprimend that their GASTONOMICAL cum levels have eclipsed solid forum advice.

And yes, Im not leaving unless you succeed in makin this forum into a scenariom of which faggot can suck the most jisum, instead of keeping it technical, professional and helpful.

'Nuf said.
GeeTek.

trolled, you poor sod. lol