Hello everyone. I apologize if this has already been answered elsewhere on the forum; I've been searching for a while and haven't found anything. Anyway, I have a Belkin Share N300 (F7D3302) router with Tomato Firmware v1.28.7501 MIPSR2Toastman-RT K26 USB Ext. It's working wonderfully, and I'm really liking it. My one beef with it, is that after rebooting, it takes like 2 extra minutes for Wifi to come back online. If I connect via ethernet cable, the web UI says that the Wireless radio is "Enabled" and broadcast is "Enabled".
I also logged in via SSH and "wl isup" reports 1. I tried "wl radio off; wl radio on" and then "wl isup" shows 1 again. But still no wireless. I wanted to make some sort of script that would turn off the LED until wireless was actually on (it turns Green long before wireless is up) but I can't seem to get an accurate reading of whether wireless "isup" or not.
After a few minutes, the wireless just appears to my computers, and I'm able to connect. I can't find any change in status in the UI, no change in status from the command line.. I don't know. I'm just a bit confused.