TomatoUSB

I have tried the latest Shibby and Toastman builds to get a Wireless Ethernet Bridge working. I am using WPA2 encryption. It will start off working, then randomly start dropping packets and lose its connection to the main router (gateway). The same results happened with no encryption. I have cleared NVRAM, reflashed, with same results.

As of now, I am forced to go back to DD-WRT because I must have 2 bridges at my office. I honestly would prefer to run Tomato. Is there a build other than the latest that allows bridging with WPA2?

Bridging worked in older versions of TomatoUSB (original builds) but only supported WPA. Since I just upgraded to N routers, I need to run WPA-2.

Any help would be greatly appreciated and I can help test anything if needed.

I have the exact same problem.
We are discussing it in a post on linksysinfo at called

using-aes-encryption-causes-ping-spiking-while-wep-does-not-bridged-e3000s.68153/

ZTE ZXV10 H618B
Tomato Firmware 1.28.0000 MIPSR1-106 K26 USB Big-VPN

v106 WEB is fine for me. I use it to play internet radio and located 10 meters from main router. My setting is WPA2 (AES)

note: I have ddwrt acting as additional AP from main router, 2 radios, WPA2 (AES) , differrent SSID and password. No issue or problems. Total I have 3 SSIDs