TomatoUSB

Hello,

I was trying to configure my Asus RT-N66u with Shibby Build 104 and WDS.
The other device is a Buffalo Airstation, set up as WDS(EC) Client.
the Buffalo has two LAN Ports and an own WLAN
Whe I plug in any devices to the Buffalos LAN port I can reach everythin in the entire network. Connecting a device by WLAN to the Buffalo this device only reches the buffalo and all devices connected to the buffalo but not the Asus router neither the devices connected to the router.

Next test was a different Access Point wired to the Buffalo by LAN-port. Same procedure as by WLAN. No connction to the router or the devices connected to the router.

There seems to be an isolation between the devices.

Running the Asus' factory firmware or DD-WRT, everything works fine.

I am used to DD-WRT for several years and I was very impressed about the new functions in Tomato, but without proper working WDS I cannot use it.

Is there a bug in TomatoUSB or is there something I might have overseen?

I played with bridge and VLAN settigns, notthing helps until now.

I would be very pleased, if anybody could give a helping hint.

TIA
Andreas

Hy folks,

problem is solved. After removing the checkmark in column "Bound to" in table "Static DHCP/ARP/IPT" problems are solved.

Thank you for this great piece of software.

By
Andreas

This so called "feature" seems to be the worst thing ever packaged with tomato, it horribly breaks nearly every bridging capability that these custom firmwares used to have.