I am have a WNR3500L running Tomato Shibby 093 All in One. I am having an issue when creating multiple VLANS. I have it working with 4 VLANS using 4 different subnets. The problem is that once I add the 4th bridge then remote access stops working. Below is a copy of the configuration from the Basic>Network screen. What I am doing is using the router to control a 24 port switch with 4 VLANS on it. It was pretty straight forward in that after setting up these bridges I just added the VLANS with tagged ports on the advanced>VLANS page. If I delete one of the bridge/DHCP setups then remote access works again, but as soon as I add the 4th like below then remote access stops working. The other problem I have is I actually need 12 VLANS, but there are only 4 bridges to pick from BR0-BR3. Is there anyway to add the other bridges so I can just use the gui to configure them on the Basic>Network screen along with the Advanced>VLAN screen?? If not can someone direct me as to how to add them? I don't know if I really need to use the bridges or not, I used them for now since that is how to make it work in the GUI. I just need to end up with 12 VLANS that all have their own subnet. By the way, all of these VLANS are on the same port on router which is connected to a 24 port switch that is setup for the VLANS. Without setting up VLANS on router also the switch ports get flooded with traffic everytime anyone uses the internet so I need the router setup with VLANS and separate subnets.
Bridge
STP
IP Address
Netmask
DHCP
IP Range (first/last)
Lease Time (mins)
br0
Disabled
192.168.1.1
255.255.255.0
Enabled
192.168.1.18 - 250
1440
br1
Disabled
192.168.2.1
255.255.255.0
Enabled
192.168.2.18 - 250
1440
br2
Disabled
192.168.3.1
255.255.255.0
Enabled
192.168.3.18 - 250
1440
br3
Disabled
192.168.4.1
255.255.255.0
Enabled
192.168.4.18
192.168.4.250
1440