TomatoUSB

I just noticed that if I try to add another line to the port forwarding list
and then I Save it all previous lines will disappear :( Is this a bug
or I'm doing something wrong?

problem #2
I like to permanently open port 554 but if I add the trigger and then check
for my open ports it still shows that the port is closed.
Can you please give me a hint how to get it working?
I temporary added one device to DMZ zone but I need to access this port
from all devices on the network

Thanks

Please make sure all your NVRAM is clear, and start from scratch.

I noticed going from a VPN version to the NON VPN version, I had some issues with my NVRAM
variables.

Port forwarding works fine for me.

I wouldn't add a device to DMZ, unless you need a machine completely open on the net.

Src Address - Only put in if you want to limited WHERE the connection is coming from. "1.2.3.4", "1.2.3.4 - 2.3.4.5", "1.2.3.0/24", "me.example.com".

Ext Ports - The ports to be forwarded, as seen from the WAN. Ex: "2345", "200,300", "200-300,400".

Int Port (optional) - While this is option, for clarity, this is the forwarding port destination.

Int Address - Machines or IP address you want that port forwarded to.

Good luck

Thanks for reply!
NVRAM was cleared for sure.
My problem is that I need to forward the same port (554) to all devices.
( 192.168.1.1 - 192.168.1.150)
Is there any way to do that ?

For clarity, this seems to be better suited to the client task and UPNP. 554 being used a lot for streaming, its a client request made on your lan side, or are you looking to serve up many streams so people can access from the internet?

I just set up a trigger for port 80 started a web server, accessed from my WAN IP and no problem.