Hi everyone. I really could use your help. I was able to flash my new router with the tomato firmware according to the instruction posted in the tutorial section no problem. I normally connect via a wireless router through the WAN port on my dsl modem-one that requires a physical username password dial in. After changing admin password, I connected the router to the modem. That's when things went awry. The router couldn't connect. So I thought maybe I need to reboot the modem and the router. I did that and the router still didn't respond. So I thought maybe I should reflash it with the recovery utility. That's when I tried to reload the router with the tomato firmware and I kept on receiving "invalid IP" error message. I remembered to reset my TCPIP to 192.168.1.1 and the subnet mask to 255.255.255.0 before I tried to reflash the router. Now the router can't even physically get into the recovery mode. I turn it on while holding the reset button and all it does is flash twice and the power light stays either solid or it goes out. I really don't know what to do here. Please help!!! Thank you!