I installed the .7484 version with built-in VLAN GUI on my RT-N16. I'm simply trying to separate the Wifi from the LAN. Would appreciate any advise on how to accomplish this via the VLAN GUI.
My attempt below was not succesful:
1. In the basic section, create a new br1 with a new IP range starting at 192.168.3.1 different from the LAN (192.168.2.1).
2. In the advanced section, I set the wireless bridge eth1 to the new br1 created in step #1.
It seems to save the new settings and reboots fine but the router is no longer appearing in the wifi client's list of available networks. If I undo #2 i.e. set the wireless bridge eth1 back to the default br0, the router becomes visible again to the wifi client.
Any suggestions? Thanks!