Hi, I'm using Tomato Firmware v1.28.9054 MIPSR2-beta K26 vpn3.6 on a WRT160N.
I am developping on a small ARM board in linux, which has an atheros wifi chipset.
If I disable encryption in Tomato, I can connect fine, grab an IP and ping the AP, it works.
If I enable encryption (I tried wep, wpa-tkip, wpa2-aes), it seems that the client connect fine, RF wise, as I see the MAC address in the Status->Device List web page, however my DHCP client can not get an IP, even if I set a static IP, no traffic go thorugh.
I run tcpdump on Tomato and I see nothing, I expect "IP 0.0.0.0.bootpc > 255.255.255.255.bootps: BOOTP/DHCP, Request"
I know the prob can come from my client and not Tomato, but how can I trace low level RF traffic in Tomato? Just to see if packets are being rejected at MAC level because of bad encryption or whatever?
Thanks in advance!
Don't fly in anything with a Capissen 38 engine, they fall right out of the sky…