Was wondering if you could add support for this router to tomato USB. it is currently supported in dd-wrt. Here are the svn sources that adds support
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9183 - main support
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9184 - more main support
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9270 - leds/reset
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9281 - radio fix
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9298 - power LED fix (replace part of 9270?)
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9343 - more radio fix
http://svn.dd-wrt.com:8000/dd-wrt/changeset/9832 - more LED fix
http://svn.dd-wrt.com:8000/dd-wrt/changeset/10431 - vlans on request
http://svn.dd-wrt.com:8000/dd-wrt/changeset/12164 - radio params update
Here is the device info from openWRT:
(page is http://wiki.openwrt.org/toh/netgear/wnr834b?s[]=wnr834b)
Architecture MIPS (low endian)
Vendor Broadcom
Bootloader CFE 1.0.37
System-On-Chip BCM4704KFBG
Processor BCM3302 v0.6
CPU Speed 264 Mhz
Flash size 4 MiB
RAM size 16 MiB
Wireless BCM4321 b/g/n Wireless (v1:mini-PCI card, v2:integrated)
Ethernet BCM5325
JTAG Yes
Serial Yes
Im willing to also run test builds as I have a jtag, and ttl adapter I can use on this unit if all else fails, or output is needed. Thanks