Here's my setup. 2 Netgear WNR3500L routers.
Router 1 is configured as my base gateway to the Internet, and wireless access point.
Router 2 I configured as a wireless bridge, and it is working. Clients attached to the ethernet on Router 2 are able to communicate with clients connected to Router 1 as well as access the Internet.
So basically this is the setup I want and it is functional. However, as soon as I turned the Wireless Bridge on on Router 2, I can no longer figure out how to connect to it to login and manage the router. I was 99% sure I assigned a static IP address on my network, but can't talk to it on that IP. I've run a IP scan of my network and don't see Router 2 listed. I've also checked the client list on Router 1 and don't see Router 2 listed as a client.
I'm running Build 53. Even though the config is working as is, I'd like to be able to login and manage the router. I was hoping to also use the connected USB features on Router 2 as well. Is this possible in wireless bridge mode? If not, I guess I'll have to configure it as a wireless client, and route traffic between the two subnets on Router 1 and Router 2.