I just got through pulling my hair out over almost the same issue. I am not sure what is causing it. I started out with Victeks latest build for RT-N16 1.28 and the bridge was from my old wrt-54gl with 1.25 Victek not sure which build atm. Now I first noticed because I have an APEX controller for an aquarium connected through the 54gl, so that I can monitor it through the network. I could not get access to it over the network with Victek 1.28 on RT-N16. So I decided to go back to Tomato Firmware v1.28.9050 MIPSR2-beta20 K26 USB vpn3.6 and now I could access the APEX again. However, in both versions, Victek's 1.28 and beta20, I noticed my laptop would not connect over wireless. I could connect on the laptop on both Victek and beta20 to the router, but not the internet. I tried for hours to get it to work and finally switched the channel width to 20 MHz in beta20, which appeared to do the trick. Seems to me that with Ethernet Bridge that 1.28 wireless may have some issues? Possibly? Who knows, I am a novice at best when it comes to networking, so I thought my experience may help.