TomatoUSB

I have a Netgear r7000 with Shibby. I locked myself out somehow and doing a nvam clear (?? pin hold reset button) I got back in with admin/admin. If I do anything to the router it logs me out and does not allow me back in with admin/admin or the pwd I know it was when this all started.

I have done this a dozen times and I am always allowed back in but then after doing anything logged out. I am able to change the pwd but after being logged out it does not accept it.

What can I do?

thanks, Bj

30/30/30 re-upload Shibby then 30/30/30 matey?

I'm about as thick as a bag of hammers. If I 30/30/30 I can use putty to load Shibby. If I 30/30/30 again don't I have to flash it again?

Speaking of the putty thing do I just transfer the image over and the router knows to flash? If that is correct how do I transfer the firmware over?

thanks, Bj

Just additional info. I tried a pin hole reset 30/30/30 and it acted just like I pressed it for 5 seconds.

I flashed it again with Shibby and it made no difference. (not the fault of Shibby).

thanks, Bj