TomatoUSB

Hi, this is Luke and I would first like to greet all the FORUM because this is my first entry. I need to ask you a bit of information that I can not find anywhere on the web …. Basically, I use firmware ADVANCED TOMATO 1.28.0000 MIPSR2-3.0-132 K26 USB Mega-VPN on my linksys E4200 v1 and use a client OPEN VPN using the service "Hide My Ass" installed directly on the router !!

Now my problem is that I would be able to connect with my iphone remote router when the OpenVPN connection is active but I can absolutely to get in !! I read around a bit I should use a service like No-IP, but I really can not figure out how to set the interface DDNS router, as I always releases errors. I do not know if the problem is in the router or in the fact of not being able to create an appropriate host on noip.com, the fact is that 10 days from now I try to solve this problem without success. Point out that no VPN connection OPEN active tranquillamnete I connect remotely to my router as I did open the door 8000 and 8001 from my WISP.
Not knowing where to look and who to turn thought to contact you hoping you can help me,

I apologize for the inconvenience and waiting for your kind reply,

cordially,

Sinito Prospero Luca.

Pretty much I would be able to turn on and off by remote VPN but I can not because once turned on, I no longer get into the router …. in various forums I found it written that you have to use a service like no-ip or dyndns but really I do not know how to do it in the settings …. my system is as follows:

Antenna ESTRENAR that leads to my home ethernet cable operator WISP signal cable is plugged into the WAN port to an tp-linlk WR841N through one of the Ethernet ports connect to the WAN port of a Cisco Linksys E4200 V1 with advanced firmware tomato and VPN configuration OPEN active. The WAN port of the tp-link releases address like 192.168.1.2 as the default gateway is 192.168.1.1 and the LAN empre of tp-link is the type 192.168.0.1 in fact the LAN port of the Cisco Linksys releases address 192.168.0.25 while the LAN subnet of the Cisco E4200 -Linksys V1 is the type 10.0.0.1 someone could help me !? I am now several days that we slam her head, unable to solve the problem …. could anyone help me figure out if I'm wrong for the case in the creation of the host or qualcos'altr ….!? or created dozens of accounts in various dybdn, no ip etc … etc …. for testing but really am not Riec deal with them !!

Many thanks to all of you in advance.