TomatoUSB

Hello, I just purchased new R7000 (Netgear) router, and uploaded tomato fw
- first the 1.18 initial, erased NVRam
- then 1.28 - erased NVRam again

Ping response (on cable, directly to router, cable cat7, lenght 50cm)
Reply from 192.168.1.1: bytes=32 time=7ms TTL=64
Reply from 192.168.1.1: bytes=32 time=57ms TTL=64
Reply from 192.168.1.1: bytes=32 time=6ms TTL=64
Reply from 192.168.1.1: bytes=32 time=13ms TTL=64
Reply from 192.168.1.1: bytes=32 time=10ms TTL=64
Reply from 192.168.1.1: bytes=32 time=27ms TTL=64
Reply from 192.168.1.1: bytes=32 time=2ms TTL=64
Reply from 192.168.1.1: bytes=32 time<1ms TTL=64
Reply from 192.168.1.1: bytes=32 time<1ms TTL=64
Reply from 192.168.1.1: bytes=32 time=8ms TTL=64
Reply from 192.168.1.1: bytes=32 time=58ms TTL=64
Reply from 192.168.1.1: bytes=32 time=26ms TTL=64

thats pretty weird, should be <1ms, whats wrong with router (or firmware?)
I tried to enable CTS (I found some hint on internet), but no change :-/

Hi

I have the same problem here.
When i ping my gateway, the latency go to 0.5ms to 1000 ms with duplicate packet !!

I changed my cables, switch and the router (also go back to release 118 shibby).

Any idea ?

Thank

Adrien

Please use the linksysinfo forum if you have questions about firmware, all these points have been discussed there in detail already.